​Internal & Industrial Flooring » ​PU Addaflake

  • ​PU Addaflake

  • PU Addaflake

    PU Addaflake is a two pack fast curing polyurethane coloured base coat designed to hold a blend of coloured paint flakes overcoated with our UV stable matt or gloss top coats to provide a surface with excellent wear and scratch resistance.

    The coloured flakes are available in a standard range of colours or bespoke finishes can be developed to create your own unique floor.

    PU Addaflake Cross Sections
    • PU Addaflake (Gloss)

    • PU Addaflake (Matt)

    Surface Preparation

    The surface to be treated should be free of laitance, oil, grease and loose friable particles which could affect adhesion. Vacuum assisted shot blasting or grinding of the surface is recommended. The substrate must have a maximum of 4% moisture content and be protected any moisture ingress from underneath.


    PU Addaflake is supplied in units ready to use comprising ‘A’ (Resin) and component ‘B’ (Hardener). First stir thoroughly contents in container ‘A’ to a homogenous consistency then scrap contents of ‘B’ into container ‘A’ and mix thoroughly for several minutes using a low speed electric drill. Use protective gloves and goggles. Failure to mix thoroughly will result in poor or non-cure applied material. Keep all components at room temperature 24 hours before use.


    The temperature of the substrate must be 3 degrees above the dew point temperature. PU Addaflake should not be applied at temperatures below 10 ̊C nor above 30 ̊C. Relative humidity should not exceed 70%. Apply the mixed PU Addaflake immediately by trowel/squeegee on to the prepared surface and back roller as quickly as possible. Particular attention should be given to areas around obstructions and protrusions making sure that all the surfaces are covered.  

    PU Addaflake Downloads

    (Click on image to download pdf)

    • PU Addaflake Datasheet


    • Internal Flooring O&M Manual