Addastone Resin Bonded Surfacing

Surface Course Requirements only

Download a PDF of this Data Sheet>>>

ALL BASE DETAILS ARE INTENDED AS A GUIDE ONLY AND DO NOT CONSTITUTE A SPECIFICATION

Concrete Slab, minimum thickness to be __mm (to take expected loads), laid in bays not exceeding 20m2 with a maximum bay length of 6m, on to a suitable Granular Sub-base Type 1 to DTLR ‘Specification for Highway Works’ to clause 803.
Allow a minimum of 28 days to cure before applying Addastone.

Alternatively, install Tarmac Toproc Microsilica Concrete reducing cure time to approximately 7 days. Further details are available on request.

Refer to Addastone data sheet for surface preparation information.

NOTE: Addstone can be laid on existing concrete or asphalt surfaces on a suitable construction for expected traffic loads. Joints and cracks in concrete should be broken out to a minimum of 200mm width and infilled with well compacted macadam base layer as indicated above as per normal good practice for flexible surfacing and does not absolve the specifier from desigining a construction suitable for expected traffic and ground conditions.

A suitable steel, wood, brick, stone or aluminium edging should be provided to ensure neat edge detail. Any advice, recommendation or information given by Addagrip Surface Treatments UK Limited is based on practical experience and is believed to be accurate at the time of publication. No liability or responsibility of any kind (including liability for negligence) is accepted in this respect by the company, its Servants, or Agents.

The figures quoted do not constitute a specification. They represent typical values obtained for this product.

Return to the Addaset Resin Bound Surfacing page>>>